Advanced Recovery Services Schedule between Comdisco, Inc. and NYFIX Millennium, LLC (NYFIX, Inc.) dated February 15, 2000

Summary

This agreement is between Comdisco, Inc. and NYFIX Millennium, LLC (NYFIX, Inc.) for advanced recovery services at Comdisco's Carlstadt and North Bergen, NJ facilities. Comdisco provides up to 250 square feet of secure, environmentally protected data center space at each location, along with equipment and 24/7 support for backup operations. NYFIX is responsible for providing equipment lists, ensuring software compliance, and covering related costs. The agreement lasts 60 months from February 15, 2000. Comdisco schedules maintenance with advance notice, and NYFIX assumes risk for its own equipment except in cases of Comdisco's negligence.

EX-10.25 4 ex1025to10k_12312003.htm sec document
 EXHIBIT 10.25 ADVANCED RECOVERY (AR) SCHEDULE DATED FEBRUARY 15, 2000 TO THE MASTER AGREEMENT DATED OCTOBER 15, 1997 BETWEEN COMDISCO, INC. ("COMDISCO") AND NYFIX Millennium, LLC (NYFIX, Inc.) ("CUSTOMER") 1. CUSTOMER FACILITY: 2. COMDISCO RECOVERY FACILITY: ------------------ --------------------------- NYFIX Millennium, LLC (NYFIX, Inc.) Advanced Recovery Facility - Carlstadt, NJ 100 Wall Street Advanced Recovery Facility - North Bergen, NJ New York, NY 10005 3. COMDISCO BACKUP CAPABILITY: ADVANCED RECOVERY SERVICES -------------------------- A. FACILITY MANAGEMENT SERVICES FACILITY - CARLSTADT, NJ Conditioned raised floor, fully secured and environmentally protected, up to a maximum of 250 square feet in the AR Services data center area in Carlstadt, NJ, as required to accommodate the physical specifications of the configuration as specified in Exhibit 1. The actual space occupied may be less than the maximum stated above. FACILITY - NORTH BERGEN, NJ Conditioned raised floor, fully secured and environmentally protected, up to a maximum of 250 square feet in the AR Services data center area in North Bergen, NJ, as required to accommodate the physical specifications of the configuration as specified in Exhibit 1. The actual space occupied may be less than the maximum stated above. SUPPORT Support will be provided on a 24 hour, 7 day per week basis using shared operations support in Carlstadt, NJ for tape mounting for backup support as per the procedures scripted, implemented, and documented by Customer. Support not specifically delineated in this schedule is not included. INFRASTRUCTURE See Exhibit 1 Comdisco may be required to make infrastructure changes to accommodate customer-owned equipment. The equipment in Exhibit 1 will be acquired by Comdisco Inc. for purposes of this Schedule and will be installed by Comdisco, Inc. within 90-150 days from receipt of Customer equipment list and is dependent upon equipment delivery by Customer. All fees for installation and infrastructure including power will be billed to customer as a pass through expense. 4. INITIAL TERM: ------------ Beginning February 15, 2000 and continuing for 60 months. 5. TEST TIME: --------- Not Applicable 6. CUSTOMER RESPONSIBILITIES: ------------------------- OPERATIONS SUPPORT Customer will provide operator support for all processing above and beyond that stated herein. Whenever Comdisco, Inc.'s performance of the Services are dependent upon Customer furnishing Comdisco, Inc. with appropriate data, documents, information, or materials, Customer will furnish all such data, documents, information, or materials in a timely fashion, and will process such data, documents, information, or materials when necessary. Customer is responsible for configuration, performance, and data integrity.  Advanced Recovery Schedule dated February 15, 2000 NYFIX Millenium, LLC. NYFIX, Inc. Page 2 of 2 - -------------------------------------------------------------------------------- SOFTWARE Customer shall comply with the use of software on the dedicated equipment as per the terms of the software license agreements with the software vendors. Customer shall indemnify, defend and hold Comdisco harmless against any claim by Customer's software licensors that Customer's use of software on the dedicated equipment constitutes an infringement of licensor's copyright of the software. Customer will be solely responsible for assuring Y2K compliance on all Customer provided software, hardware and firmware. If Customer furnishes software to Comdisco, Inc. for use by Comdisco, Inc. in providing the AR Services, Comdisco, Inc. may review and test the software in advance of its use to determine the software's compatibility with Comdisco, Inc.'s equipment, software and firmware, as well as the software's consistency with Comdisco, Inc.'s data processing techniques. If the software is incompatible with or adversely impacts the provision of the AR Services, Comdisco, Inc. will not be obligated to use the software. EQUIPMENT Comdisco will provide equipment listed on Exhibit 1 for the locations listed. The equipment and telecommunications currently installed in the Comdisco Carlstadt facility and associated with contract #52RS4838-00 will remain in place. Customer is to provide Comdisco with an equipment list within 45 days of signing this schedule, The equipment list will include any equipment retained from the current schedule, indicated above, any new equipment to be added by Customer and any telecommunications equipment or circuits being provided. The equipment list must indicate which equipment will be provided with dual power or single power feeds, any equipment not so indicated will be assumed to be single fed equipment. Planning and installation of infrastructure and electrical capabilities cannot be implemented by Comdisco until such time as the equipment list is made available. Customer may add or substitute equipment in the Equipment Configuration during the term of this Schedule with thirty (30) days written notice provided this would not require additional space. Any costs associated with these changes, (e.g., power, environmentals, installation, etc.), will be the responsibility of the Customer. Should this configuration require additional space beyond that contracted for in this agreement, it will be subject to availability at a rate of $120 per square foot. Customer agrees to pay all in-transit insurance, transportation, installation, de-installation and maintenance costs associated with the Customer-Provided Equipment. See Exhibit 1. Customer assumes the risk of loss for the Customer-Provided Equipment. Comdisco is not responsible for, and Customer releases Comdisco from any liability relating to, any physical loss of, or damage to, the Customer-Provided Equipment or Customer data on the Customer-Provided Equipment, except any loss caused by Comdisco's negligence. EQUIPMENT CONFIGURATION See Exhibit 1 7. BACKUP CAPABILITY SPECIAL OPTIONS: --------------------------------- Not Applicable 8. TELECOMMUNICATION SERVICES: --------------------------- See Exhibit 1. 9. MAINTENANCE: -----------  Advanced Recovery Schedule dated February 15, 2000 NYFIX Millenium, LLC. NYFIX, Inc. Page 3 of 3 - -------------------------------------------------------------------------------- Comdisco reserves the right to schedule maintenance for up to two (2) 24-hour periods annually. The maintenance periods will occur on Sunday and are scheduled on an annual basis. These time periods are used, WHEN REQUIRED, for major facility upgrades, hardware movement, major system software upgrades/testing as well as UPS testing and maintenance of the facility power infrastructure. Customer will be notified in writing thirty (30) days in advance when these periods are scheduled. Following the relocation to the new Carlstadt facility, Comdisco will supply power to dual fed equipment in a manner that will allow for continuous planned operation. The equipment must be dual fed and be placed as requested by Comdisco. The power infrastructure enhancement prevents the equipment from being powered down during Comdisco's planned maintenance windows. Comdisco will supply power to single fed equipment in a manner that will allow for continuous planned operation with the exception of maintenance to the PDU supplying the single fed equipment. The power infrastructure enhancement prevents the equipment from being powered down during Comdisco's planned maintenance windows except when maintenance to the attached PDU is being performed. Comdisco will strive to place duplicate equipment on multiple PDUs. Maintenance windows will not be scheduled at both Comdisco's Carlstadt and North Bergen facilities concurrently. Unforeseen downtime and unscheduled remedial maintenance may interrupt Customer's access to the Advanced Recovery Services. As a result, Customer's access to the Advanced Recovery Services may not be continuous and uninterrupted. Comdisco agrees to minimize the duration and impact of any such occurrence on the availability of the Advanced Recovery Services to the maximum extent possible 10. FEES: ---- ONE-TIME CISCO EQUIPMENT FEE..............$ 500,595 (THIS FEE INCLUDES SALES TAX) PAYABLE WITHIN 14 CALENDAR DAYS FROM CONTRACT SIGNATURE BY CUSTOMER A. MONTHLY SERVICE FEE......................................................$ 67,791 MONTHLY FEE FOR COMMUNICATIONS FROM SUPERSEDED SCHEDULE...................$ 3,152 MONTHLY TOTAL.................................................................$ 1 (FEBRUARY 15, 2000 THROUGH APRIL 14, 2000, 2 MONTHS) MONTHLY TOTAL............................................................$ 30,000 (APRIL 15, 2000 THROUGH MAY 14, 2000, 1 MONTHS) MONTHLY TOTAL............................................................$ 70,943 (MAY 15, 2000 THROUGH FEBRUARY 14, 2005, 57 MONTHS) B. DISASTER NOTIFICATION FEE.....................................................N/A  Advanced Recovery Schedule dated February 15, 2000 NYFIX Millenium, LLC. NYFIX, Inc. Page 4 of 4 - -------------------------------------------------------------------------------- SPECIAL TERMS: -------------- A. This Schedule supersedes the Schedule and all Riders to the Schedule dated October 15, 1997 between Comdisco and Customer (the "Previous Schedule") (Contract #52RS4838-00). This Schedule begins and the Previous Schedule terminates on February 15, 2000. The upgraded Backup Capability may not be available for previously scheduled Test Time. This Schedule is confidential information of Comdisco for Customer's internal use only and is issued pursuant to the Master Agreement identified above and is a separate Agreement. All of the terms, conditions, representations and warranties of the Master Agreement are incorporated herein and made a part hereof. ACCEPTED: NYFIX Millennium, LLC (NYFIX, INC.) COMDISCO, INC. By:/s/ Richard A. Castillo By: /s/ John Jackson John Jackson Title: Richard A. Castillo, Title: President, Continuity Services CFO, Secretary NYFIX Millennium Date: February 16, 2000 Date: 3-17-00  Advanced Recovery Schedule dated February 15, 2000 NYFIX Millenium, LLC. NYFIX, Inc. Page 5 of 5 - -------------------------------------------------------------------------------- CONFIGURATION DETAILS EXHIBIT 1 CISCO HARDWARE (COMDISCO PROVIDED EQUIPMENT) - -------------------------------------------- QTY. PRODUCT NUMBER PRODUCT DESCRIPTION - ---- -------------- ------------------- 4 CISC07507/4X2 CISCO 7507 7-SLOT, 2 CYBUS, 2 RSP4, DUAL POWER SUPPLY WITH: (2) 7507s will be located in North Bergen and (2) 7507s will be located in Carlstadt, both with the associated hardware listed below in each facility: 1 S75C-12.0.5T Cisco RSPx Series IOS IP 2 MEM-RSP4-256M RSP4 256MB DRAM Option 2 MEM-RSP4-FLC20M RSP4 Flash Card: 20 MB Option 2 VIP2-40 Versatile Interface Processor-2, model 40 2 MEM-VIP240-64M 64 MB DRAM Option for VIP2-40 1 PA-2T3+ 2 Port T3 Serial Port Adapter Enhanced 1 PA-2FEISL-TX 2 port Fast Ethernet/ISL 100BaseTx Port Adapter 1 PA-4T+ 4 Port Serial Port Adapter, Enhanced 1 CON-SNT-7507 SMARTnet 8x5xNBD for CISCO7507 CISCO7206VXR CISCO 7206VXR, 6-SLOT CHASSIS, 1 AC SUPPLY W/IP SOFTWARE WITH: (2) 7206s will be located in North Bergen and (2) 7206s will be located in Carlstadt, both with the associated hardware listed below in each facility: PWR-7200/2 Cisco 7200 Dual AC Power Supply Option, 280W C7200-I/O Cisco 7200 Input/Output Controller MEM-1/O-FLC20M Cisco 7200 I/O PCMCIA Flash Memory, 20 MB Option NPE-300 Cisco 7200VXR Network Processing Engine 300 MEM-SD-NPE-256MB 256MB Memory for NPE-300 in 7200 Series PA-2FEISL-TX 2 port Fast Ethernet/ISL 100BaseTx Port Adapter PA-2T3+ 2 Port T3 Serial Port Adapter Enhanced PA-4T+ 4 Port Serial Port Adapter, Enhanced CON-SNT-7206 SMARTnet 8x5xNBD for Cisco 7206 Modular Router Catalyst 5500 Switches to support Dark Fiber Communications between the two facilities